Cracking

-


In petrochemistry, petroleum geology and organic chemistry, cracking is the process whereby complex organic molecules such as kerogens or long-chain hydrocarbons are broken down into simpler molecules such as light hydrocarbons, by the breaking of carbon-carbon bonds in the precursors. The rate of cracking and the end products are strongly dependent on the temperature and presence of catalysts. Cracking is the breakdown of a large alkane into smaller, more useful alkanes and alkenes. Simply put, hydrocarbon cracking is the process of breaking a long-chain of hydrocarbons into short ones. This process might require high temperatures and high pressure.

More loosely, outside the field of petroleum chemistry, the term "cracking" is used to describe any type of splitting of molecules under the influence of heat, catalysts and solvents, such as in processes of destructive distillation or pyrolysis.

Fluid catalytic cracking produces a high yield of petrol and LPG, while hydrocracking is a major source of jet fuel, Diesel fuel, naphtha, and again yields LPG.

credits wiki






Comments

Post a Comment

Popular posts from this blog

Online, inline, atline and bypass (analysers)

-
Image
Inline : For inline analysis, a sensor can be placed in a process vessel or stream of flowing material to conduct the analysis. Online : Analysers which are connected to a process, and conduct automatic sampling, can be called online (or on-line) analysers or sometimes inline (or in-line) analysers. This means that online and inline analyses permit continuous process control. Offline and atline analyses, on the other hand, are characterized by manual sampling followed by discontinuous sample preparation, measurement and evaluation. The material properties can change during the time between sampling and the availability of the results, so direct process control is not possible. A bypass line is recommended in terms of process control to prevent a shutdown or lost product. If you have to clean, calibrate or validate ypour analyser a lot, then a bypass is the best solution.
Read more

Thermal conductivity detector (TCD)

-
Image
The thermal conductivity detector (TCD), also known as a Katharometer, is a bulk property detector and a chemical specific detector commonly used in gas chromatography.[1] This detector senses changes in the thermal conductivity of the column effluent and compares it to a reference flow of carrier gas. Since most compounds have a thermal conductivity much less than that of the common carrier gases of helium or hydrogen, when an analyte elutes from the column the effluent thermal conductivity is reduced, and a detectable signal is produced. The TCD consists of an electrically heated filament in a temperature-controlled cell. Under normal conditions there is a stable heat flow from the filament to the detector body. When an analyte elutes and the thermal conductivity of the column effluent is reduced, the filament heats up and changes resistance. This resistance change is often sensed by a  Wheatstone bridge  circuit which produces a measurable voltage change. The column effluent
Read more

Pour point

-
Image
The pour point of a liquid is the temperature at which it becomes semi solid and loses its flow characteristics. In crude oil a high pour point is generally associated with a high paraffin content, typically found in crude deriving from a larger proportion of plant material. That type of crude oil is mainly derived from a kerogen Type III. credit wiki
Read more